Exclusively designed by Ehpro, the Tyr rda (rebuildable drip attomizer) is made from SUS 303 stainles steel with a diameter of 29.7mm. Exceptionally stylish and the ideal atomizer for your existing 26650 sized mechanical mods. The unique 5 posts allows a wide range of coil set up configurations and massive vapor production. The top cap is equipped with air holes to adjust different draw capacity performance. Each Tyr RDA is attached with copper contact pins for superior conductivity. The underside of the top cap also has a large conical design that can alternatively decrease turbulent airflow or low pressure usage. Finally, the drip tip that is included, has a easy grip to remove from your top cap without difficulty.
Posted by Ozonicus on 19th Dec 2015
Great quad DRA
Had it for about a month now and I am not sorry I bought it. I have tried a few different guages / diameters of coils and found it to be an easy deck to build on. Were I to change anything about this RDA it would be to have the center post holes staggered slightly or just a tiny bit bigger. When you are threading 24 ga wire through you may have to thread the screw down a bit after the 3rd coil so as to scrunch the leads down a bit so that it will make passing the lead for the fourth coil through with a minimal amount of hassle.
Great RDA for sub OHM quad coilers!
This product does not carry any warranty and we only guarantee that you will not receive it DOA (Dead on Arrival).