Crown 3 Atomizer Coil Heads by Uwell (4pcs)

Crown 3 Atomizer Coil Heads by Uwell (4pcs)

In the stainless steel chassis of each replacement atomizer head lies a single vertical parallel coil utilizing a SS316 heating element—primarily used with a device's VW or Power Mode, these heads can also be used with your mod's temperature control mode for stainless steel. In addition, these replacement coils for Uwell's Crown III and Crown III Mini sub-ohm tank are incredibly to remove and replace, thanks to the inventive pull-and-plug system that doesn't rely on picky threads to get your head to stick—instead, these heads use sturdy o-rings that allow the coil head to slide in and out for replacement.

Features

• Stainless Steel Chassis
• Organic Cotton Wicking
• Quad Wicking Ports
• SS316 Heating Element
• Parallel Coil
• Vertical
• Available in:
• 0.25 ohm (80W-90W)
• 0.4 ohm (55W-65W)
• 0.5 ohm (70W-80W)

Box Contents

•  4x Crown 3 Atomizer Coil Heads by Uwell

WARNING: This tank uses sub-ohm resistance coils which your device may not support safely. Due to the increased risk when used incorrectly, extra safety precautions should be practiced when using a sub ohm tank. This tank will only work on devices capable of firing sub ohm resistances and handling high amp loads. For mechanical mod users, please use batteries capable of 30A continuous or higher. If you're using a regulated mod, make sure both it and your batteries can handle the amperage. Improper use can lead to injury or damage. Take extra care to check with your ohm meter, ohms law calculator and amperage drain in order to stay safe! If you have any further inquiries, feel free to contact us by email.